Shop

Stangengreifer - System für den Automatikbetrieb

Gripping tool to pull Out of rod material – Ø 3 – 90 mm from the lining of the CNC lathe and CNC machining centre in the automatic mode.

Use for :
  • Production of small and medium-sized series of rods and
  • Transfer of workpieces

The rod gripper was developed in 1998 and since then has been successful in customers and in our own manufacturing use.

The Advantages:
  • Mode of operation: rapid traverse 30 m / min
  • Accuracy: +/- 0.1 mm (without stop)
  • low set-up time
  • Gripping pliers to attach the gripper jaws
  • Gripping pliers in the tool data to describe and measure
  • no damage to the surface of steel to be machined around
  • Taper shank available in all sizes and designs.
Stangengreifer (mit Greiferbacken) Set A/B-Ø8mm-42mm
Rod gripper (with jaws) Set A/B Ø8mm-42mm
Stangengreifer (mit Greiferbacken) Set C/D-Ø43-90mm
Rod gripper (with jaws) Set C/D-Ų43-90mm
IMG_4639
Stangengreifer (ohne Greiferbacken)-Ø3mm-7mm
Rod hook (without jaws)-Ø3mm-7mm
Product Information
Position 1:
  • Signal: Spindle Stop
  • Rod gripper is positioned in rapid traverse to the middle of the spindle in front of the Material
Position 2:
  • Rod gripper linear in the rapid (30 m / min) with the corresponding jaw on the rod (approx. 4 mm are sufficient)
  • Rod gripper linear in the rapid (30 m / min) with the corresponding jaw on the rod (approx. 4 mm are sufficient)
Position 3:
  • Rod gripper has pulled the Material in the rapid (30 m / min) to the desired Position
  • Signal: Chuck close automatically
  • Rod gripper moves linearly in front of the bar
  • Signal: spindle rotation (the editing can begin again)